It’s “Knot” Shellac works to help seal in tannins and block stains with a clear touch. It has all the same benefits of a shellac except it is “Knot”. It’s “Knot” Shellac can be used as a pre-surface conditioner on raw wood before a stain is applied to maintain an even, non-blotchy outcome. This is a great product for woodworking and furniture projects.
Blocks Stains and Tannins
Penetrates & Seals Wood Grain Fibers minimizing Grain Raise and creating a Waterproof Barrier.
Can be used on: Bare Wood, under Paints, and under Topcoats.
Brushed or Spray Application
Does not Yellow or Amber.
1 coat covers 400 square feet/Gallon.
1.Sand bare wood with 220 grit sandpaper.
2.Apply by brushing or spraying.
3.When brushing, perform the “dip and drip” method. Avoid wiping excess product off on sides of container.
4.When spraying, wear a mask to avoid air particles being ingested.
5.Apply 1 coat and allow to dry 30 minutes to 1 hour.
6.Lightly scuff sand to remove any raised wood grain fibers.
7.Apply additional 1-2 coats to seal wood and provide a smooth surface.